CUTTING TOOLS AND OPERATIONS QUIZ 2 irshadalam@1 August 20, 2021 0 Fitter Quiz CUTTING TOOLS AND OPERATIONS QUIZ 2 270 Created on August 20, 2021 CUTTING TOOLS AND OPERATIONS QUIZ 2 1 / 9 1) Both sides of a flat bastard file have no cut single cut teeth double cut teeth wavy teeth 2 / 9 2) The leng th of hacksaw blade is measured from one end of the toothed portion to the other end centre of one pin hole to the centre of other pin hole end to end of blade end of one hole to the end of the other pin hole 3 / 9 3) The new hacksaw blade should not be used in the blind saw cut made by old blade because the space is not enough to run the blade the blade is costly the new blade has sharp teeth none of the above 4 / 9 5) File card is used for cleaning the chips cleaning the file teeth cleaning the workpiece renewing the file teeth 5 / 9 6) Setting of teeth in hacksaw blade is not required required to avoid friction between the blade and workpiece required for providing teeth on the blade required for increasing the strength of blade 6 / 9 7) A Ø 6H7 hole is to be reamed in a steel workpiece. What size of drill will be required? 5.5 mm 5.8 mm 6.0 mm 6.2 mm 7 / 9 8) Which one of the following materials is used for making a grinding wheel ? Granite Silicon carbide Sand Calcium carbonate 8 / 9 9) Spot-facing is done to make surface flat so that bolt head can take proper seat on the surface. g hole. make surface flat so that bolt head can take proper seat on the surface. give fine finish to the drilled hole. deburr the mouth of the drilled hole enlarge the existin 9 / 9 10) For tapping with M5 tap, what size drill will you use? 4.0 mm 3.5 mm 4.5 mm 3.8 mm Your score isThe average score is 59% LinkedIn Facebook Twitter VKontakte 0% Restart quiz fitter theory quizfitter trade theoryfitter trade theory multiple choice questionsfitter trade theory quizitiiti fitter book mcqiti fitter quiziti quiz
